Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

User

Haidar Jabbar

Joined on the:

Oct. 28, 2020

Score

22390

Comment(s)

38

Voted question(s)

2

Voted answer(s)

10

Votes up

0

Votes down

12

Votes up received

0

Votes down received

0

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

0

Golf R no power on 4 pin datalink connector with THAR-VW1

Hello. I got it all connected. Plugged in the and no power on the evo. No LEDs turned on. I tried to check the voltages and no volts. I made sure the harness is plugged in. Any ideas?

04/02/2023

Kia n h (230Pts.)

0

Key fobs won't program evo one installed in a 2013 kia soul

2013 kia soul, automatic w/o immobilizer. When entering programming I get the flashing blue light on the antenna but can not get the solid confirm light.

0

Toyota sequoia

I have sequoia 2010 standard key How i program my remote in the flash link app it said for me it requires RF kit but i have remote and also i saw many peoples in YouTube they start it up without RFKit they start the car with the OEM remote please can you give the steps so i can flash it with OEM remote

03/02/2023

Jeep Nev (130Pts.)

0

Jeep has power but does not crank?

I have programmed the unit sn: 001A07 415854 Evo All. Installed with wiring harness THAR-CHR4 (Both Yellow wires on the harness are connected together). Programmed the unit. All these went according to the documentation, correct leds and all.

My vehicle is a 2011 Jeep Grand Cherokee 3.0CRD Limited with Start Button

I do the 3x Lock Blue Led comes on every time I press the lock button. Then all power comes on, a few seconds later the red and yellow led is solid and the radio shuts off just like it does while it cranks but no crank??

What could I be doing wrong?

Many Thanks!!

0

Chevrolet colorado 2006

 

 

I have programed a evo all )1a07248861) for colorado 2006 standard key, using it with a remote start crimestopper rsg4, everithing is fine with de programation, the door  lock and unlock is working fine.

 

but the problem is when i want to start it, the lighs turn on , the inition , accesory, etc. but the car never run with de starter and it doesnt starte,  the evo all stay whith de lihgs yellow and red solid and the lights never turn off.

 

i tried programing diferents evo all and the same thing happened with them.

votes

 

I have programed a evo all )1a07248861) for colorado 2006 standard key, using it with a remote start crimestopper rsg4, everithing is fine with de programation, the door  lock and unlock is working fine.

 

but the problem is when i want to start it, the lighs turn on , the inition , accesory, etc. but the car never run with de starter and it doesnt starte,  the evo all stay whith de lihgs yellow and red solid and the lights never turn off.

 

i tried programing diferents evo all and the same thing happened with th

 

0

red light on all the time

red light is on all the time

30/12/2022

Honda drrck (130Pts.)

0

Takeover steps/procedures for 2013 Accord PTS

Hi. Is takeover possible on 2013 Accord PTS? If so what's the procedure? Currently it shuts off when I get in and push the brakes.

0

Wire to Keysense

Hello guy, What wire, to connect on the keysense wire of the car? Thanks.

0

2010 Sierra Standard Evo-All THARGM4 No Alarm Functions

Programming was successful, vehicle starts, door locks continue to work via factory remote. Evo-all seems to be monitoring door switches as it will shut down if a door is opened when locked. However no alarms sound whether that's the factory alarm or evo-all. What could be the problem here? I was looking to supplement the factory alarm with evo-alarm for shock/glass break sensors. I'd settle for just the factory alarm working again.

0

2016 crv wont start after program

I went throught the installation, held button and plugged in then hit 3x then turned ignition on and waited for blue flash then ran decrypter and installed and the car will not start with 3x lock.... they sent me a new module and same thing. Am i doing something wrong?

0

t harness eve-all with standard key Camry 2011

the wiring diagram in guide does not match colors for camry 2011, does the t-harness work with evo-all?

0

2008 dodge ram 3500 diesel standard transmission

2008 dodge ram 3500 6.7 cummins with a manual transmission, I've installed the evo one with a t harness. The module programs properly, but when I press the lock button 3 times to start the module clicks a few times but does nothing.

0

Ignition turns on but won’t crank

I just my oem remote and the trucks ignition turns on but it won't start the hood pin is disabled as I don't have one on my truck 2009 f150

0

Disable remote start button

Is there a way to disable the remote start button and go back to just using the lock 3 times to remote start? Or change the behavior so that the remote start needs to be pressed with another button. I keep starting the truck while the key is in my pocket. Thank you

0

2016 Chevrolet Malibu standard key Evo One

Hi guys. Do you know if there is any solution for the 2016 chevy malibu limited flip standard key? It happens that all the connectors match the 2015 connections but the colors do not. I would like to install an Evo one with RF kit. I've been looking on the website but I don't see anything for this car specifically. Any recommendation? Thanks.

0

Looking for the install guide for an 08 saturn astra with an evo one.

select filters for avalible guides? it does not list any install guides under the evo one for the 08 saturn astra. any help would be great.

0

2017 EvoOne with TharFor3 T harness, blue light won't blink on programming

Thank you in advance for any help! I am a long time using of the EVO ALL and have done a few EVO ONE. A bit stumped on my 2017 F150 though. Using EVO ONE with the THAR FOR 3 harness. All plugged in. Following wiring diagram for the A1 and A16 (put them together) on the white 20 pin connector. When I go to program it, I can't get it to "blink blue". Therefore, I can't get any further in the programming procedure. Followed the directions in the Guide. What could I be missing? Joe

0

2007 Camry will evokey work for a key but not programmed chip

I have a key that can go into ignition but the chip is not programmed. I have a remote start. Does evokey bypass imobliizer and allow remote start

0

Hi, can you verify starter wire location for 2015 Hyundai azera?

I started installing Evo one on 2015 Hyundai azera, the ignition wires are big 12 gauge wire and the starter is wire is tint, like 20 or 22 gauge and the starter wire from Evo one is big thick wire. Also do you know where the horn wire is located? Do I just turn on alarm function and hookup the horn?

0

compatability with 2009 PT Cruiser

Installed EVO-All in 2009 PT Cruiser. I have checked and rechecked the install / wiring and programming. Unfortunately, it will not start the vehicle. Seems to go thru the cycle, even turning on the fuel pump, however, despite the device responding and acting as though its going to start the vehicle thats all it does. Any suggestions please... THANKS, Alan

0

MyCar and Fortin EVO-ONE with T-Harness setup on Subaru Outback 2017 Standard Key not working

I'm trying to add MyCar to a Fortin EVO-ONE installation on a Subaru Outback 2017.   The Fortin EVO-ONE works fine - I can start the car using the OEM Standard KEY/Remote without any issues. I followed the steps provided in the install guide to add the MyCar   Protocol is set up to Fortin2  using the FlashLink MAnager on EVO-One for RFKit Setup as Fortin in the MyCar application Settings.   I did the following steps to learn the MyCar into Fortin EVO-One 1- Cycle the ignition to the ON position. 2 - The YELLOW LED on top of the EVO-ONE should come ON. 3 - Press and Hold the EVO-ONE push button for 5 seconds. 4 - The parking lights and the RED LED on the side of the EVO-ONE will turn ON. 5 - Release the push button. 6 - Press and Release the push button 5x times. Everytime the push button is pressed the parking lights and the RED Led on the side of the EVO-ONE will blink. 7 - Then Press and Release the Brake pedal. 8 - Seconds later the RED LED on the side of the EVO-ONE will blink once to confirm that the MyCar ID has been learned to the EVO-ONE. 9 - Cycle the vehicle’s ignition to the OFF position to Exit the EVO-ONE programming   All steps succesful.      In the MyCar app I can see the voltage of the car and the GPS  location, however the START/STOP/LOCK/UNLOCK functions are not working from the MyCar application     Any ideas/help?   Thanks VO

0

Evo-one to 2009 diesel ram tach hookup and which mode

How does the system know when the vehicle has started. Do I need a tach hookup. Also which tach mode do I program the evo-one. Is it tachless mode, or the other. 2008 diesel ram 2500

0

Clutch bypass 22 Corolla

Just wondering why we need to make the clutch bypass so elaborate on 22 Corolla hatchback push to start. we have two ignition + from the evo one going to pin 86 of the relay and wire a4 -ignition to pin 85 of the relay? And then 30 and 87 to the clutch switch. Could we not just run e6 yellow from connector e directly to the clutch switch as we have done on previous models just looking for clarification here Thank you

30/03/2022

Toyota Moike (580Pts.)

0

programming rf kit 441 on 2008 toyota sienna with evo one 002B04170603

Rf441 with 4 button programming instruction please? 002B04 170603 Thanks, Moike

No results

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

TECHNICAL SUPPORT

Search through our most popular products and installation topics available in our Question & Answers section.

Learn more
Download our step-by-step troubleshooting guides app available for both iOS and Android or browse through our desktop version.

Learn more
Access the industry’s largest online wiring diagrams & photo database. A free token is provided in every EVO-SERIES box.

Learn more
You did not find the information that you were lookingfor? Ask us a question by filling out the technical support form request. A product specialist will answer you shortly.

Learn more
From state-of-the-art vehicle remote control and connectivity solutions to premium technical support, learn why you should choose Fortin products.

Learn more

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue